2 Knowledge Base

 

 TelecomTrainning.net > Knowledge Base > (Network +) Certification
 Article Listings
Good Evening, - Please register or - log-in to your account.
Search
Search   Saved Questions   Ask a question
Keywords 
 
Available categories
LTE
100 of Questions in LTE
CCNA Certification
CCNA Sample Q & A (1000 + Q &A)
(Network +) Certification
(Network +) Sample Q & A (1000 + Q &A)
Networking
General/Interview Q& A on Networking
Home Networking
General/Interview Q& A on Networking
VOIP, SIP & Asterisk
Q & A on VOIP,Ethereal, SIP & Asterisk
Telecom Test Equipments
Q & A on Telecom Test Equipment
PSTN / Wireline
General / Interview Q & A on PSTN / Wireline
LTE, Wireless, 3G ,Diameter and HSS
General/Interview Q & A on LTE, Wireless, 3G ,Diameter and HSS
Telecom General
Any Q & A in Telecom in General

Top Questions
Friends, Describe Secure storage and distribution of A-Keys?
what is the difference between E1 signal & Ethernet signal ?
How do I monitor SS7 Traffic in spectra2?
Can you tell me about PBGT?
Explain me the difference between a repeater, bridge and router? Relate this to the OSI model.
What is the difference between BRI & PRI ?
Guys what is the purpose of Umbrella Cell Approach in GSM ?
how can we explain media gateway in MSc?
What is GGSN?
What is the difference between Electrical-tilt and Mechanical-tilt of an antenna?
What is BSC?
What is demarc point?
Can any one explain me how sms flow will work using ss7 network ?( from physical layer to application layer)
why cellphone towers are painted in red and white?
Explain SLTA and SLTM messages in MTP3?
Hi guys what is WAP?
wat is the difference betweem MSC & GMSC, & MSS & GCS?
what is EDAp? what is the functions of EDAP?
What is a circuit id?
what is sdh?

(Network +) Certification
1000Base-SX cable segment has max length of ?
Frankyoung - 11-December-2007 12:20:17 PM
 Single-mode fiber-optic cable is used in 100Base-FX or 1000Base-SX or 10 GBase-ER or 10 GBase-LR?
eric - 11-December-2007 12:07:07 PM
 1500 nm laser beam is used in 10GBase-ER or 1000Base-SX or 10 GBase-ER or 10 GBase-LR?
jhon186 - 11-December-2007 12:07:04 PM
 1300 nm laser beam is used in 10GBase-ER or 1000Base-SX or 10 GBase-ER or 10 GBase-LR?
jhon186 - 11-December-2007 12:06:56 PM
 UTP copper cabling is used in 100 Base-TX or 1000Base-CX or 10 GBase-ER or 10 GBase-LR?
areil - 11-December-2007 12:06:49 PM
 150ohm copper cabling and HSSDC is used in 100 Base-TX or 1000Base-CX or 10 GBase-ER or 10 GBase-LR?
elie - 11-December-2007 12:05:37 PM
 Why Fiber Distributed Data Interface (Token Ring network) uses two counter rotating rings?
elvin - 11-December-2007 12:05:32 PM
 Fiber Distributed Data Interface uses Half duplex or Token passing access method?
bretpark - 11-December-2007 12:05:27 PM
 IEEE 802.4 uses Half duplex or Token passing access method?
terrylee - 11-December-2007 12:05:23 PM
 Which one Star or bus topology require min cable ? Why?
terrylee - 11-December-2007 12:05:19 PM
 
Page:  1  2  3  4  5  6  7 8  9  10  11  12  13  14  15  16  17  18  19  20  21  22  23  24  25  

Search questions via popularity
Top viewed questions  Top emailed questions  Most printed questions  Most saved questions
 
Copyright © Telecom Training, All Rights Reserved